1. <button id="hffry"></button>
      <th id="hffry"></th>

      <dd id="hffry"></dd>

      <dd id="hffry"><pre id="hffry"></pre></dd>
    2. <rp id="hffry"></rp>

      <th id="hffry"></th>
      歡迎來到山東豪潤裝飾工程有限公司官網!
      全國咨詢熱線:1786660745615253122210
      您的位置:首頁>> 產品中心>>單層玻璃隔斷
      單層玻璃隔斷尺寸
      • 單層玻璃隔斷尺寸

      單層玻璃隔斷尺寸

      彈線:根據樓層設計標高水平線,順墻高量至頂棚設計標高,沿墻彈玻璃隔斷垂直標高線及天地龍骨的水平線,并在天地龍骨的水平線上劃好龍骨的分檔位置線。

      在線咨詢 服務熱線17866607456     
      產品詳情

      彈線:根據樓層設計標高水平線,順墻高量至頂棚設計標高,沿墻彈玻璃隔斷垂直標高線及天地龍骨的水平線,并在天地龍骨的水平線上劃好龍骨的分檔位置線。

      Bullet Line: According to the high level line of floor design, design elevation from wall to ceiling, cut off vertical elevation line and horizontal line of skyscraper and skyscraper along wall bullet glass, and draw the grading position line of skyscraper on horizontal line of skyscraper and skyscraper.

      條安裝大龍骨:1.地骨安裝:根據設計要求固定天地龍骨,如無設計要求時,可以用Ф8~Ф12膨脹螺栓或3~5寸釘子固定,膨脹螺栓固定點間距600~800mm。安裝前作好防腐處理。2.沿墻邊龍骨安裝:根據設計要求固定邊龍骨,邊龍骨應啟抹灰收口槽,如無設計要求時,可以用Ф8~Ф12膨脹螺栓或3~5寸釘子與預埋木磚固定,固定點間距800~1000mm。安裝前作好防腐處理。

      Installation of large keel: 1. Ground bone installation: Fixed skyscraper according to design requirements. If there is no design requirement, it can be fixed with expansion bolt 8-12 or 3-5 inch nail. The space between fixed points of expansion bolt is 600-800mm. Antiseptic treatment should be done before installation. 2. Installation of keel along the wall: According to the design requirement, the keel should be fixed, and the plastering receptacle should be opened. If there is no design requirement, expansion bolts of 8-12 or 3-5 inch nails can be used to fix the keel with embedded wooden bricks. The spacing between the fixed points is 800-1000mm. Antiseptic treatment should be done before installation.

      主龍骨安裝:根據設計要求按分檔線位置固定主龍骨,用4寸的鐵釘固定,龍骨每端固定應不少于三顆釘子。必須安裝牢固。

      Main keel installation: According to the design requirements, the main keel should be fixed according to the position of the grading line and fixed with 4 inch nails. Each end of the keel should be fixed with no less than three nails. It must be firmly installed.

      小龍骨安裝:根據設計要求按分檔線位置固定小龍骨,用扣榫或釘子固定。必須安裝牢。安裝小龍骨前,也可以根據安裝玻璃的規格在小龍骨上開安裝玻璃槽。

      Small keel installation: According to the design requirements, the small keel is fixed according to the position of the grading line, and fixed with a mortise or nail. It must be firmly installed. Before installing the keel, the glass groove can also be opened on the keel according to the specifications of the installation glass.

      安裝玻璃:根據設計要求按玻璃的規格安裝在小龍骨上;如用壓條安裝時先固定玻璃一側的壓條,并用橡膠墊墊在玻璃下方,再用壓條將玻璃固定;如用玻璃膠直接固定玻璃,應將玻璃先安裝在小龍骨的預留槽內,然后用玻璃膠封閉固定。

      Installation glass: Install the glass on the keel according to the specifications of the glass according to the design requirements; For example, fix the press strip on one side of the glass first, and use rubber pad under the glass, then fix the glass with the press strip; If fix the glass directly with glass glue, the glass should be installed in the reserved slot of the keel first, and then sealed and fixed with glass glue.

      打玻璃膠:首先在玻璃上沿四周粘上紙膠帶,根據設計要求將各種玻璃膠均勻地打在玻璃與小龍骨之間。待玻璃膠完全干后撕掉紙膠帶。

      Glass glue: Firstly, paper tape is glued around the glass. According to the design requirements, all kinds of glass glue are evenly struck between the glass and the keel. Tear off the paper tape when the glass glue is completely dry.

      安裝壓條:根據設計要求將各種規格材質的壓條,將壓條用直釘或玻璃膠固定小龍骨上。如設計無要求,可以根據需要選用10×12mm木壓條、10×10mm的鋁壓條或10×20mm不銹鋼壓條。

      Installation bar: According to the design requirements, the bar of various specifications and materials will be fixed on the keel with straight nails or glass glue. If the design is not required, 10 *12 mm wood, 10 *10 mm aluminum or 10 *20 mm stainless steel can be selected according to the need.http://www.cnruochen.com/

      熱品推薦
      網站地圖 亚洲.欧美.日韩在线旡码_伊人丁香五月综合婷婷_日本丰满熟妇videossex_黃色三級片请播放